Gear motors: How are gear motors installed?

1. First, when installing the gearbox, couplings, pulleys and other connecting parts must be installed on its output shaft. Clogging is not allowed when installing these connecting parts. After all, the design of the output shaft of the gear motor will not withstand an axial hammer blow. We can screw some screws into the holes at the end of the shaft to compress it. Thus, the device will be able to withstand the axial force of the impact.

2. The choice of the diameter of the output and input shafts should be coordinated to a certain extent, do not choose blindly. In addition, when installing the gearbox, it is necessary to pay attention to the ring bolt on the gearbox. It is only used to lift the gearbox, and other types of gear heads cannot be installed arbitrarily, because different types of gear motors have different properties and requirements. Therefore, during the installation process, it is necessary to pay attention to these points.

3. When installing the gearbox, it is necessary to check the height of the installation center line of the gear motor and the corresponding dimensions of the connected parts. The concentricity of the mounting shaft after calibration must not exceed the permissible range of the coupling. During calibration, steel or cast iron gaskets must be used to increase the height. The design of the buffer gaskets should also not cause deformation of the housing, since sometimes the pressure on the buffer gaskets can be relatively high, which can lead to deformation of the housing after exposure to high pressure. They can be arranged symmetrically on both sides of the foundation bolts, and their mutual distance can also ensure free flow of water during irrigation.

The above describes how to install a gear reducer. Shandong Anjifu Transmission Equipment Co., Ltd. is a professional manufacturer of gear motors, if you have any requirements, please feel free to consult.